9.5mm Zelor Ring Snaps

If you want quality in metal snaps - look no further.

In this one listing you will find everything you require to attach 9.5mm Zelor Ring Snaps: the press machine, die sets, and the snaps themselves

SNAP PRESS & 9.5mm Zelor DIE SETS are required to attach these snaps. You cannot use a hammer, nor can you use other die sets 

2-PIECE VS. 3-PIECE DIE SET

We currently have the option of the 3-piece die set, with a separate top die for studs (male) and sockets (female) - this necessitates changing the die over when you wish to switch from applying sockets to studs, and vice-versa

OR

A 2-piece die set, with a top die that does both studs and sockets - no changing over dies to do each part!

TOP DIE ONLY

We also have for a limited time, this top die available on its own.  This is an option for those who have already purchased the 5-piece Zelor die set in the past and wish to upgrade it to the single top die.

If you are new to these Zelor snaps, and do not already own the 5-piece or 3-piece Zelor die set, then this is not the product for you

9.5MM ZELOR RANGE - MIX & MATCH

You can mix and match all of the products up within the 9.5mm Zelor range. The stud and the sockets are the same for the ring snaps as well as for the cap and pearl snaps - so if you want to conserve your Pearl Snaps, and get Ring Snaps to go on the inside - you can. Given the studs and sockets are the same - your ability to mix and match to suit gives endless options in the Zelor range

The Pearl and Cap range require their own bottom die, these were included with the 5-piece Zelor Snap die sets, or can be found with the pearl and cap snaps listings, if you do not already have these.